Table of Contents
Advertisement
Empty the sawdust collection bag regularly.
Open the zip fastener to empty the bag.
Unlocking and switching
L
the machine on and off
j
Unlock the machine by pushing the safety lever
to the right.
Switching on:
j
Press the On / Off switch
Note: There is a delay in the machine starting up
.
Switching off:
j
Release the On / Off switch
j
Secure the machine again by moving the saw
motor unit
downwards and pressing the
Q
transport lock
to the left.
o
Switching the laser on and off
L
and adjusting it
Avoiding harm from the laser beam!
The laser beam indicates the cutting line of the saw
blade. Align the marks on your workpiece with the
track of the laser beam.
Switching on:
j
Press the laser On / Off switch
Switching off:
j
Press the laser On / Off switch
Adjusting the laser beam:
j
Turn the laser setting screw
laser beam.
Setting the speed
L
You can pre-select the speed you require using
the rotation speed selector wheel
E
and keep it pressed.
D
.
D
into position I.
i
into position 0.
i
to adjust the
H
.
F
Increasing speed:
j
Turn the rotation speed selector wheel
towards marking 6 or in the + direction
(6= highest speed).
Reducing speed:
j
Turn the rotation speed selector wheel
towards marking 1 or in the – direction
(1= lowest speed).
Transporting the machine
L
j
Before you transport the machine always lock
the transport restraint by engaging the transport
lock
with the saw motor unit
o
When you carry the machine always hold it by
the base.
Attaching the laminate cutting
L
attachment and cutting laminate
The patented laminate cutting attachment
you to cut laminate to your required lengths quickly
and cleanly. Note that the laminate cutting attach-
ment
is designed exclusively for laminate and
{
a material width of up to 20 cm. It is suitable for
almost all types of commercially available laminate
floor coverings.
j
Loosen the two stop plate
using the supplied 6 mm Allen key (d) and re-
move the stop plate.
j
Insert in its place the laminate cutting attach-
ment
and screw it to the saw table
{
j
Place the laminate flush against the edge of
the stop of the laminate cutting attachment
Mitre cuts – turning the saw table
L
j
Loosen the setting knob for saw table
the mitre angle stop
using the saw table setting knob
right into the desired position. Release the mitre
angle stop
again and tighten the saw table
I
setting knob
.
O
Operation
F
F
lowered.
Q
allows
{
setting screws
q
.
T
{
. Press
O
and turn the saw table
I
to the left or
O
GB/IE
.
T
11
Advertisement
Table of Contents
