Page 1
Kompernaß GmbH Burgstraße 21 D-44867 Bochum (Germany) Last information update: 07 / 2007 · Ident.-No.: PKGS1450 Laser - 072007-1 / UK / IE ChOP aND mitre saw CHop and mitre saw pKGs 1450 Laser Operating and safety instructions Before you begin reading this information, please unfold the page with the illustrations and familiarize yourself with all functions of the tool.
Attaching the laminate cutting attachment and cutting laminate ... Page Mitre cuts – turning the saw table ... Page Inclined cuts – inclining the saw motor unit ... Page Making a combination cut ... Page Changing a saw blade ... Page Tips and tricks ...
20 cm wide. Please note that the blade pre-installed in the saw as supplied is intended for use with wood only. Any other use or modification to the device shall be considered as improper use and could give rise to considerable dangers.
Carry out the following before each use: - check the saw for damaged parts or safety equipment and if necessary have them replaced by an electrician. - check the saw blade for quality / condition, sharpness, cleanliness and free movement.
Page 6
Do not cut workpieces too small. Your hand must always be at least 10 cm away from the saw blade. Do not attempt to saw extremely small work- pieces.
In that way you will prevent the saw blade from being blocked. Operation Assembly Do not connect the chop and mitre saw to the mains before you have worked through the following assembly instructions and completely assembled the device. 1. Slide the lateral support stirrups...
Then try turning the saw blade manually. It must be able to turn freely. If the saw blade does not turn freely, carry out the necessary adjustment by turning the setting screw 4a.
Switching the laser on and off and adjusting it Avoiding harm from the laser beam! The laser beam indicates the cutting line of the saw blade. Align the marks on your workpiece with the track of the laser beam. Switching on:...
(put on the flange, tighten the screw in the counter- clockwise direction). Always check that you have inserted the saw blade so that it rotates in the correct direction. You will find the direction of rotation marked on the saw blade and the saw motor unit...
EN61000-3-3 EN61000-6-1 EN61000-6-3 EN61029-1 EN61029-2-9 EN60825-1 Description of the product: Chop and mitre saw PKGS 1450 LASER Bochum, 31.07.2007 Hans Kompernaß - Managing Director - We reserve the right to make technical modifications in the course of further development. GB/IE...