Removing The Unit - Kenwood KDC-X717 Instruction Manual

Removing the Unit

I
Removing the hard rubber frame
Insert the removal tool into the indentations in the hard rubber
frame, and pull it gently until the lock is released.
I
Removing the Unit
1
2
3
Accessory0
Removal tool
4
2CAUTION
Be careful to avoid injury from the catch pins on the removal
tool.
5
— 46 —
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
Remove the Hex-head screw with integral washer (M4×8) on
the back panel.
Insert the two removal tools deeply into the slots on each
side, as shown.
Accessory4
Accessory3
Removal tool
Push upward the removal
tool toward the top, and
pull out the unit halfway
whilst pressing towards the
inside.
Pull the unit all the way out
with your hands, being
careful not to drop it.
Catch facing up