Led Lighting; Diverter Knobs; Air Venturis - Cal Spas F-168 Owner's Manual

3.14 LED Lighting

Press the LIGHT button on the topside control
panel to turn the spa light on. If your spa has perimeter LED lights, they will also light on. If your spa has
perimeter LED lights, they will also light up at the same time as the spa
light.
The LEDs operate in three modes:
1. Cycle: When you continually press the LIGHT
button, the LEDs will cycle through the three
main LED colors (Red, Green, and Blue) or
combinations of the three that produce the
following colors: light green, purple, light blue,
yellow, etc. Each time you press the button, you
immediately advance ti the next color in sequence
or eventually a different light pattern.
2. Flashing: Once you have cycled through all of the
colors, another press of the LIGHT button will
produce a flashing pattern.
3. Fading cycle: The next phase of operation when
you push the LIGHT button is a slow and/or fast

3.15 Diverter Knobs

Diverter knobs are 1" and 2" knobs located around the top of your spa. They
allow you to divert water through jets from one side of the spa to the other, or
in most cases from floor jets to all jets. This is accomplished by rotating the
diverter knob to the left (counter-clockwise), decreasing the amount of water
flow through a sections of jets. To increase the amount of water flow through
the other section of jets, rotate the handle to the right (clockwise).

3.16 Air Venturis

9
fade random transition from one color to the
next.
• If a spa is equipped with more than 100 points of
light the slow fading cycle will flicker during a
color change.
• Every air valve is equipped with 2 LED points.
• Perimeter LEDs take 9 points of light.
• The waterfall takes 4 points of light.
Spas with exterior corner LED lighting generally work
in the same mode as described above. The variations
in color and patterns provide you with multiple
options to suit almost any lighting preference.