Filter Replacement - Honeywell HPA060 Series Owner's Manual

Hepa allergen remover air purifiers
Hide thumbs Also See for HPA060 Series:
Table of Contents

Advertisement

Available languages

Available languages

ELECTRONIC FILTER CLEAN REMINDER
These air purifier models each have two electronic filter checks
to remind you when to check and replace the HEPA Filter(s) and
Household Gas & Odour Reducing Pre-Filter based on the air
purifier's hours of use.
When the HEPA Filter(s) need to be replaced, a red LED on the
Check Filter(s) button will come on and remain on until it is RESET.
You may unplug the air purifier without interrupting the filter check.
A red LED on the "Check Pre-Filter" button will illuminate when it
is time to replace the pre-filter.
You should periodically check these filters. Depending on operating conditions, the HEPA Filters should be
replaced every 12 months, and the Household Gas & Odour Reducing Pre-Filter every 3 months, especially if
there have been heavy odours in the home.
To RESET Either Electronic Filter Check:
When a filter check light remains on, it is time to replace the HEPA or Pre-Filter and reset the filter check light.
With the unit powered on, press the lighted button and hold for approximately 2 seconds until the light turns off.
Depending on individual usage (environment and hours used), you may need to check and replace filters more or
less frequently.
These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent upon the
concentration of contaminants going through the system. High concentrations of contaminants such as dust, pet
dander and smoking will reduce the useful performance of the filter.
NOTE: None of the filters are washable. DO NOT immerse them in water.

FILTER REPLACEMENT

See INSTALLATION INSTRUCTIONS on page 4 of this manual.
The Certified HEPA Filter
HEPA
Replacement Filters are available in 2 pack sizes, HRF-H1C (single pack) or HRF-H2C (2 pack).
H
Filter
If you would like your air purifier to remain effective at reducing household odours, and to operate most
effectively, you should replace the Household Gas & Odour Reducing Pre-Filter once every 3 months.
This pre-filter is available as the Household Gas & Odour Reducing Pre-Filter
To help ensure stated product performance, use only Genuine Honeywell Replacement Filters.
H
should be replaced one time per year for optimum performance. The Certified
Filter
HPA060/HPA064
Fig. 5
Will illuminate when it is time to change HEPA filters
+
B
Pre-Filter
6
HPA160/HPA164
or model HRF-B2C (2 pack).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hpa160 seriesHpa064 seriesHpa164 series

Table of Contents