Carburettor Adjustment - Jonsered CS 2240 Workshop Manual

Jonsered chainsaw user manual
Hide thumbs Also See for CS 2240:
Table of Contents

Advertisement

Carburettor adjustment

Conditions during adjustment
The air filter should be clean and the cylinder
cover fitted when adjustments are made. Ad-
justing the carburettor with a dirty air filter will
give a too lean fuel mixture the next time the
air filter is cleaned. This can result in serious
damage to the engine.
Mount, for this model, approved bar and
chain combination (see Technical data in the
Operator's Manual).
CS 2240/S 16"
The chain should not be tensioned more than
that it remains ~ 0,2 inches to the bar.
(See figure 43)
Replacement of the H-needle or complete car-
burettor
1. Carefully screw the new H-needle to the bot-
tom and turn it anticlockwise "A" turns.
CS 2240/S A = 2
2. Start the engine. If necessary, adjust the idling
speed with the T-screw until the chain stops.
3. Adjust the H-needle to give a top speed of "B"
rpm. Use a tachometer.
CS 2240/S B = 12500-13 000, speed limitation
Use screwdriver 530 03 55-60.
4. Let the engine run at "B" rpm ~ 1 minute, until
warm.
Replacement of the L-needle
1.
Screw the new L-needle to the bottom and
then turn it counterclockwise "D" turns.
CS 2240/S D = 2,5
(See figure 44)
Fig 43
L
Fig 44
Repair instructions
H
T
41
English –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs 2240s

Table of Contents