Procedures for Lowering the Cassette holder assembly
As the mechanism of this unit is integrated with the Housing
assembly, the holder must be lowered and the two screws un-
screwed when removing the Mechanism assembly.
(A)
(B)
Fig. 1
Turn the loading motor pulley in the direction as indicated by
Fig.2. As both (A) and (B) levers are lodged twice, push the
levers in the direction as indicated by Fig.3 to release them.
When pushing the levers, do it in the order of (A), (B), (B),
(A). When the holder has been lowered, turn the pulley until
the cassette holder is securely in place without allowing any
up/down movement.
Procedures for Lowering the Cassette holder assembly
(S1a)
(S1c)
Fig. D1
1-2
Fig. 2
Fig. 3
(S1b)
[1]
Top cover
(S1a)
(S1a)
(S1c)
[1]
Bracket
b<Note 2a>
(L2a)
(L2a)
(L2b)
[2]
Front
(L2c)
panel
assembly
Front panel
backside
(S2a)
WR2a
<Note 2b>
ADV. Jog board
assembly
Fig. D2
Note: When installing the Drum assembly, secure the screws
(S3a to S3c) in the order of a, b, c.
Not used
Inertia plate
(S3c)
(S3a)
(L3a)
(P3)
(L3b)
Roller arm
assy
[3]
Drum
assembly
CN1
Fig. D3
a<Note 2a>
CN3012
WR2a
<Note 2b>
(L2b)
CN7004
Drum shield
(S3d)
WR3a
<Note 2b>
CON1
WR3b
(S3b)
<Note 2b>
Cleaner assy
(L3c)
Not used