Adjusting Cutting Height - Scag Power Equipment STC Operator's Manual

4.13 ADJUSTING CUTTING HEIGHT

The mower deck can be adjusted from a height of 1-inch
to 5-1/2 inches at 1/2-inch intervals. To adjust the cutting
height:
WARNING:
Do not adjust the cutting height with the mower
blades rotating. Disengage the power to the cutter
blades and then adjust cutting height.
1. Disengage the power to the cutter blades.
2. Push the cutting height adjustment foot pedal all the
way forward using your right foot until it locks in
place. (Figure 4-5).
3. Insert the lanyard pin into the cutting height index at
the desired cutting height. Push forward on the deck
lift foot lever, hold in place and lift up on the deck
release lever, (Figure 4-4). Slowly release the foot
pedal. A deck height decal is located on the cutting
height index as an aid in adjusting the deck to the
desired height. (Figure 4-5).
DECK
RELEASE
LEVER
Figure 4-4 Deck Release Lever
All manuals and user guides at all-guides.com
STC99DRL
14
LANYARD PIN
HEIGHT ADJUSTMENT PEDAL
Figure 4-5 Adjusting Cutting Height
Section 4
STC99ACH