LG DLEX89 0 Series Owner's Manual page 54

54 TROUBLESHOOTING
Problem
Clothes have damp
spots after a SENSOR
DRY cycle.
Steam Functions
Problem
Water drips from
nozzle when Steam
Cycle starts.
Garments still
wrinkled after Steam
TM
Fresh .
Creases or pleats are
gone from garments
TM
after Steam Fresh .
Garments have static
after using the
Reduce Static option.
Garments are too
damp or too dry
after using the
Reduce Static option.
Steam does not
generate, but no
error code is shown.
Water drips from
door during Steam
Cycle.
Steam is not visible
during Steam Cycle.
Drum does not turn
during Steam Cycle.
Cannot see steam
vapor at the
beginning of cycle.
Odors remain in
clothing after Steam
TM
Fresh .
Very large load or very small load. Single large item such as a blanket or comforter.
• If items are too tightly packed or too sparse the sensor may have trouble reading the
dryness level of the load. Use a MANUAL DRY cycle for very small loads.
• Large, bulky items such as blankets or comforters can sometimes wrap themselves into a
tight ball of fabric. The outside layers will dry and register on the sensors, while the inner
core remains damp. When drying a single bulky item, it may help to pause the cycle once
or twice and rearrange the item to unwrap and expose any damp areas.
• To dry a few remaining damp items from a very large load or a few damp spots on a large
item after a SENSOR CYCLE has completed, empty the lint trap, and then set a MANUAL
DRY cycle to finish drying the item(s).
This is normal.
• This is steam condensation. The dripping water will stop after a short time.
Too many or overly different types of garments in dryer.
• Small loads of 1 to 5 items work best. Load fewer garments. Load similar types of
garments.
The function of this cycle is to remove wrinkles from fabric.
• Use an iron to replace creases and pleats in garments.
This is normal.
• The amount of static experienced will depend on the individual moisture level in the skin.
Correct drying options not selected.
• Select the load weight manually before starting the Reduce Static option.
Water level error.
• Unplug dryer and call for service.
This is normal.
• Condensation will normally form on the inside of the dryer door during steam operation.
Some condensation may drip out the bottom of the door.
This is normal.
• Steam vapor is difficult to see when the door is closed. However, condensation will
normally form on the inside of the dryer door if the steam system is operating normally.
This is normal.
• The drum is turned off so that the steam vapor remains in the drum. The drum will
normally turn for about 2 seconds once a minute.
This is normal.
• Steam is released at different stages of the cycle for each option.
Steam Fresh™ did not remove odor completely.
• Fabrics containing strong odors should be washed in a normal cycle.
Possible Cause & Solution
Possible Cause & Solution