Location And Function Of Parts And Controls; Front; Rear - Sony UP-D70 Service Manual

Location and Function of Parts and Controls

For details, refer to the pages indicated in parentheses.

Front

1 UPOWER switch
Press to turn the printer on or off.
2 Fan cover (9, 28)
Provided to prevent the printer from dust.
3 Ribbon door (14)
Pull the tab (marked with PULL) on the top
on the ribbon door to open it when loading an
ink ribbon cassette.
4 PRINT QTY (quantity) button (22)
Press this button to display or close the print
quantity setting menu in the printer window
display.
5 Printer window display
Displays the status messages. In menu
operation, the print quantity setting menu,
printout adjust menu or gray balance adjust
menu is displayed.
Also, SCSI device type is dipslayed.
If an error occurs, a corresponding error
message is displayed.
6 ALARM indicator (32)
Lights in orange when the ink ribbon or print
paper is exhausted, the paper jams, or another
problem occurs.
6 Introduction
7 MENU button (13, 23, 25)
Press this button to display or close the
printout adjust menu, gray balance adjust
menu and SCSI device type setting menu in
the printer window display.
8 Cursor control buttons (13, 22, 23, 25)
Use these buttons to increase or decrease a
value and level shown on the menu, or scroll
up and down through a menu.
9
STOP button (20)
Press this button to stop printing part-way.
0
PRINT button (19, 20, 22)
Press this button to print the image data
stored in the memory of the printer.
!¡ Paper cover (9)
Printouts are ejected here.
!™ Paper tray (9)
Load print paper here. Press the point
marked with PUSH to remove the paper
tray.

Rear

UP-D70A
1 PARALLE DATA IN (Amphenol 36-
pin) (10) (only UP-D70A)
Used to connect a Windows computer via the
parallel interface, using the parallel interface
cable. (not supplied)
2 SCSI/Centronics interface board and
memory board (11) (only UP-D70A)
Used to connect a Windows or Macintosh
computer or another SCSI device, through the
SCSI cable. The other connector is loop-
through connector. If either of the two
connectors is not being used, set the
terminator of the DIP switch to ON.
(See "Setting the DIP Switch" on page 11.)
3 DIP switch (11) (only UP-D70A)
Used to set the SCSI ID number and the built-
in terminator to ON or OFF.
(See "Setting the DIP Switch" on page 11.)
4 ⁄AC IN connector (12)
Used to connect to a wall outlet, using the AC
power cord supplied.
UP-D70
5 Expansion slot for Color Connectivity
Controller
Remove the cover and insert the TMax P891
Color Connectivity Controller (not supplied).
For detailed information on how to insert, see
the instruction manual supplied with TMax
P891.
Introduction 7