Operation - Silvercrest SKGL 2000 A1 Operating Instructions Manual

Operation

RISK OF BURNS!
Caution! Hot surface!
The surface of the appliance can become extremely hot during
►
use. Touch the appliance using only the handle.
NOTE
► Unwind all of the mains cable from the cable retainer
appliance.
1) Close the appliance lid using the handle.
2) Slide the fat drip tray
3) Insert the plug into the mains power socket. You will hear a beep and "OFF"
will appear on the display
automatically after 1 minute if no further entries are made.
4) Switch on the appliance using the On/Off button
lights up blue, there will be a beep and the appliance starts to heat up to
the preset temperature of 90°C (keep-warm mode). Once the temperature
has been reached, you will hear three beeps and the green "Ready" control
lamp
5) Press T/MIN button
pressing the "+"
reached, the green "Ready" control lamp
up. If the appliance has already reached the set temperature, you will hear
two beeps and the green "Ready" control lamp
6) If required, press the T/MIN button
(1–90 min.) using the "+"
lamp
temperature is maintained. As soon as the heating period is over, you will
hear two beeps and the appliance will switch back into keep warm mode
(90°C). The appliance switches off automatically after 1 hour if no entries
are made.
7) Switch the appliance off by pressing the On/Off button
mains power plug from the wall socket.
■ 12 │ GB │ IE │ NI │ CY
into the appliance.
. The display lights up blue and goes out
lights up. The light element
and set the desired temperature (90–230°C) by
and "-" buttons. If the set temperature has not yet been
and "-"
lights up again as soon as the set heating level is reached and the
when you use the
. The display
lights up blue during operation.
goes out and the appliance heats
will light up.
again to adjust the heating duration
buttons. The green "Ready" control
SKGL 2000 A1
and pull the