Download Print this page
PAC RadioPRO4 Manual

PAC RadioPRO4 Manual

Radio replacement & steering wheel control interface for ford/lincoln/mercury vehicles
Hide thumbs Also See for RadioPRO4:

Advertisement

Quick Links

Introduction & Features
The RP4-FD11 interface allows the replacement of a factory radio in select Ford/Lincoln/Mercury vehicles with MSCAN
databus radios. Using this interface will retain factory features such as steering wheel controls (SWC), rear seat
entertainment (RSE), Rear Seat Controls (RSC) and the THX or Sony amplifier when the original radio is removed. The
RP4-FD11 also provides data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS),
illumination, reverse trigger and parking brake.
Important Notes
1.The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting
before plugging the interface into the vehicle (see below for setting chart).
2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by pressing
and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to flash 4 times.
3. RSC & LCD buttons that are identical to the SWC will mimic the SWC one for one. All other buttons cannot be programmed.
4. The LED will flash whenever a SWC button is pressed.
5. The RSC must be in AM mode for Track +/- to function. RSC must be set to AUX mode to pass audio to aftermarket radio.
6. Vehicles equipped with a factory amplified system must disconnect SYNC if they wish to use the voice button. Not disconnecting
SYNC will result in the rear speakers muting every time the voice button is pressed.
7. Feeding too strong of an audio signal into the headrest monitors will cause the audio output to shut down. If this happens you
must turn the tv off and on and lower the audio signal.
Wiring Connection Chart
Interface Connector
Red / White
P.B. Output (-)
Purple / White
VSS Output
Blue / White
Amp Turn On Input
Red
Acc. Output (1 amp)
Orange / White
Illum. Output (+)
Green
Reverse Output (+)
Pacific Accessory Corporation
Pacific Accessory Corporation
Radio Replacement & Steering Wheel Control Interface
Vehicle Connector
Yellow
Battery +12v
Black
Ground
Blue
Antenna On Input
White
Front L + input
White / Black
Front L - input
Grey
Front R + input
Grey / Black
Front R - input
Green
Rear L + input
Green / Black
Rear L - input
Purple
Rear R + input
Purple / Black
Rear R - input
| Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
®
©2011 Pacific Accessory Corporation
www.pac-audio.com
RP4-FD11
for Ford/Lincoln/Mercury Vehicles
SWC Connector
Blu/Yel
Kenwwod, Newer
JVC, OEM or
Blaupunkt
3.5mm Jack
Alpine, JVC,
Clarion, Pioneer,
Sony, Valor, Boyo,
Dual, Visteon or
Advent
Rev. 112811
Page 1

Advertisement

loading

Summary of Contents for PAC RadioPRO4

  • Page 1 Rear L - input Purple Rear R + input Purple / Black Rear R - input Pacific Accessory Corporation | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com ® Rev. 112811 ©2011 Pacific Accessory Corporation www.pac-audio.com Page 1 Pacific Accessory Corporation...
  • Page 2 5. Connect the SWC wire according to the chart on page 1 (aftermarket radio MUST support a wired remote input). 6. If you wish to reassign functions to the SWC follow the programming instructions in the next section. Pacific Accessory Corporation | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com ® Rev. 112811 ©2011 Pacific Accessory Corporation...
  • Page 3 Answer Call Receive Phone Reject BT Hangup End Call Voice Dial Voice Activation Power Pacific Accessory Corporation | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com ® Rev. 112811 ©2011 Pacific Accessory Corporation www.pac-audio.com Page 3 Pacific Accessory Corporation...
  • Page 4 4. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened. 5. The LED & radio will turn off when RAP turns off or the drivers door is opened. Pacific Accessory Corporation | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com ® SWC Connection Rev.
  • Page 5 RSE to operate properly. Being in acc mode will cause erratic behavior. Product Updates (Firmware) The RP4-FD11 can be updated with new firmware as it becomes available using the PAC-UP interface updater (sold seperatly). Please visit www.pac-audio.com/firmware for available updates. Pacific Accessory Corporation | Santa Ana, California 92705 | Ph.

This manual is also suitable for:

Rp4-fd11