Hunter 45018 Installation And Operation Manual page 13

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-9. Remove the three lower switch housing screws, then remove the
lower switch housing.
7-10. To uninstall the light fixture, first disconnect the plug
connectors between the two black wires.
7-11. Disconnect the plug connectors between the two white
wires.
7-12. Uninstall the nut and washer from the end of the light
fixture inside the lower switch housing.
7-13. Unscrew the threaded rod of the light fixture from the
lower switch housing.
7-14. Remove the light fixture from the lower switch housing
pulling disconnected wires through the hole in the
center of the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other
plug connector (female) through the hole.
7-15. Install the dummy terminals (included in the sack parts)
on the two disconnected wires in the lower switch
housing.
7-16. Install the switch housing cap and plug button to the
lower switch housing.
7-17. Re-attach the lower switch housing back to the fan and
reinstall the lower switch housing screws.
12
45018-01 • 01/29/08 • Hunter Fan Company
Steps 7-12 – 7-16
Cap
Plug Button
Lower Switch
Housing
Threaded Rod
Step 7-16