Sunrise Medical Zippie TS Owner's Manual page 21

E N G L I S H
You will need to adjust your chair from time to time for best performance
(especially if you alter the original settings). This chart gives you a first solution, then a second
and a third if needed. You may need to look farther to find the best solution for a specific
problem.
NOTE– To keep track of your progress, make only ONE change at a time.
SYMPTOMS
   
   
 

   



  
  
SOLUTIONS
Make sure tire pressure is correct and equal in both
rear tires and front caster tires, if pneumatic.
Make sure all nuts and bolts are snug.
Make sure all spokes and nipples are tight on radial
spoke wheels.
Use Tri-Flow Lubricant (Teflon
modular frame connections and parts.
Check for proper caster plate adjustment.
See instructions for caster plate adjustment.
Add a spacer washer between the plastic saddle and
the caster plate on the top of the left caster plate.
Add a spacer washer between the plastic saddle and
the caster plate on the top of the right caster plate.
Add a spacer washer between the plastic saddle and
the caster plate on the bottom right caster plate
retaining bolts.
Make sure there is an equal number of camber
washers on each axle plate.
Make sure both front casters touch the ground
simultaneously. If they do not, add the proper spacers
between the bottom bearing of the caster plate and
fork stem nut until they do. Make sure you check for
this problem on a flat surface.
® -based) between all
21 XXXXXXX Rev. A