Advertisement
three.
Operation
Mode
Procedure
Off
Receiver/amplifier off
On
Receiver/amplifier on and playing program material
Standby
Simply turn off your receiver/amplifier. The subwoofer will
turn off after approximately five minutes. The subwoofer
will turn on when your receiver/amplifier begins playing again.
Volume
min
max
Volume
Crossover Frequency
The crossover-frequency knob
crossover frequency that
determines the highest fre-
sounds best with your
quency your subwoofer will
speakers.
reproduce. It allows a seam-
When the control is at the
less transition from the
"50" position, very few high
subwoofer to the satellite
frequencies will be heard.
speakers. Experiment with
This position is best suited
this adjustment to find the
to large main speakers. For
Troubleshooting
If you used the high-level
(SPKR) inputs and there is
no sound from any of the
speakers, check the
following:
• Receiver/amplifier is on
and a source is playing.
• Powered subwoofer is
plugged in.
• Check all wires and connec-
tions between receiver/
amplifier and speakers. Make
sure all wires are connected.
Make sure none of the
speaker wires are frayed,
cut or punctured.
• Review proper operation
of your receiver/amplifier.
All manuals and user guides at all-guides.com
min
max
Volume
most users, the control should
be set somewhere near the
mid position. For listeners
using very small speakers,
best results will be obtained
with the control at the "150"
position.
If there is low bass output,
If you used the line-level
check the following:
inputs and there is no
sound from the subwoofer,
• Make sure the connections
check the following:
to the left and right "Speaker
Inputs" have the correct
• Receiver/amplifier is on
polarity (+ and –).
and a source is playing.
• Make sure that the sub-
• Powered subwoofer is
woofer is plugged into an
plugged in.
active electrical outlet.
• Check all wires and con-
• Powered subwoofer is
nections between receiver/
plugged in.
amplifier and subwoofer.
• Adjust the crossover point.
Make sure all wires are con-
nected. Make sure none of
the wires are frayed, cut or
punctured.
• Review proper operation of
your receiver/amplifier.
LED Status
Red
Green
Red
Advertisement
