Optional Parts - JUKI HZL-30Z Instruction Manual

All manuals and user guides at all-guides.com

Optional parts

Invisible zipper foot
1.
Check the zipper opening size. Install
the standard presser foot (A).
Pattern to be used
Fabric
(wrong side)
HZL-30Z HZL-60
Since a seam does
not appear on the
Place two pieces of fabric face to face. Baste the
right side of fabric,
fabric from the edge of fabric to the opening end.
opening can be fin-
At the opening end, change the stitch length to
ished with fabric
[2.0] and sew reverse stitches by 1 cm and sew
edges neatly butted.
until the predetermined position is reached.
Neatly open the seam allowance.
CAUTION:
Make sure to turn
off the machine
3.
before changing
the presser foot.
Undo the basting stitch seam to the bot-
tom of opening as shown in the sketch
given in step 1. Then, open the zipper.
5.
Sew the remaining zipper tape on the other side of seam
allowance in the same procedure. (The lower portion of
zipper tape located below the bottom of the opening will
remain loose without sewn on the seam allowance.)
Basting
Runstitch
2.5 cm
Reverse stitch (1 cm)
Invisible
zipper foot
Teeth
2.
Basting
Fabric
(wrong side)
Cardboard
Put the invisible zipper on the fabric so that its
center meets the seam line. Place a cardboard
between the seam allowance and front fabric.
Manually baste both sides of seam allowances
and zipper tapes.
Upon completion of basting, remove the card-
board.
4.
Aligning the teeth of either zipper tape with the groove
on the zipper foot, sew the zipper at the very edge of
the teeth from the end of opening while raising the teeth
with fingers.
6.
Tape
Seam Fabric
Take out the slider and pull it out to ap-
pear on the right side of the fabric.
Basting
(only zipper tape and
seam allowance)
Invisible zipper
(wrong side)
Invisible
zipper foot
Tape
Seam
Fabric
Teeth
Slider
22