To Install Batteries; Important Battery Information - Hasbro Furby 59294 Care Manual

To Install Batteries

Use a Phillips/cross head screwdriver to loosen
screw in battery compartment cover (screw
stays attached to cover) on the bottom. Insert 4
X 1.5V "AA" or LR6 size alkaline batteries (not
included). Replace cover and tighten screw.
CAUTION: TO AVOID
BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow
the toy and battery manufacturers' instructions;
2. Do not mix old and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from
the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure
to insert item correctly by matching the + and – polarity markings.
2. Do not mix old and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it
away from other electrical equipment. Reset (switching off and back on again or
removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries.
Always remove from the product before recharging. Recharge batteries under
adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
1