Table of Contents
Advertisement
Fault
Tableware is not dry.
Plastic tableware is
not dry.
Cutlery is not dry.
Appliance interior still
wet after wash cycle.
Cause and troubleshooting
Position tableware at an angle where possible.
▶
The combined detergent used has a poor drying per-
formance.
Use rinse aid to improve drying performance.
1.
Use a different combined detergent with a better
2.
drying performance.
Extra Dry not activated to improve drying perform-
ance.
Activate Extra Dry.
▶
Tableware removed too early or drying process not
yet ended.
Wait until the programme ends.
1.
Only remove tableware 30 minutes after the pro-
2.
gramme has ended.
Rinse aid used has a limited drying performance.
Use a name-brand rinse aid.
▶
Eco products may have limited effectiveness.
Not a fault. As plastic does not store heat so well, it
also does not dry as well.
No remedial action possible.
▶
Cutlery not arranged properly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery contact points.
Arrange cutlery individually where possible.
1.
→ Page 29
Avoid points of contact.
2.
Not a fault. The condensation drying principle causes
water droplets in the tub – they are indeed desirable
here. The moisture in the air condenses on the inside
walls, runs off and is pumped out.
No action required.
Troubleshooting en
39
Advertisement
Table of Contents
