Rails; Detaching And Refitting The Rails - Siemens iQ700 Instruction Manual

pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.

Detaching and refitting the rails

:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Pull out the pull-out forwards.
1.
Push the front rail forwards and up (fig.
2.
detach it (fig. ).
"
Then swing the entire rail outwards
3.
at the rear (fig. ).
ƒ
#
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
) and
!
and detach it
‚
Inserting the holders
If the holders fall out when you remove the rails, these
must be re-inserted.
The holders at the front differ from those at the rear
1.
(fig. ).
!
Use the hook to mount the front holder at the top
2.
into the round hole
‚
it at the bottom, and straighten it
Use the hook to attach the rear holder into the upper
3.
hole and push it into the lower hole
‚
Attaching the rails
When hanging the rails, ensure that the pull-out is at the
bottom.
The rails only fit on the right or the left side. The pull-out
rails must pull out forwards.
Hold the rear of the frame at an angle and mount it
1.
at the top and bottom
Pull the rail forwards (fig.
2.

Rails

, set it at a slight incline, attach
(fig. ).
ƒ
"
(fig.
ƒ
(fig. ).
‚
!
).
"
en
).
#
27