Specific Safety Warnings - Harbor Freight Tools 95082 Set Up And Operating Instructions Manual

h. Only use safety equipment
that has been approved by an
appropriate standards agency.
Unapproved safety equipment may
not provide adequate protection. Eye
protection must be ANSI-approved
and breathing protection must be
NIOSH-approved for the specific
hazards in the work area.
4. Power tool use and care
a. do not force the power tool. use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b. do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot
be controlled with the switch is
dangerous and must be repaired.
c. disconnect the plug from the
power source and/or the battery
pack from the power tool before
making any adjustments, changing
accessories, or storing power
tools. Such preventive safety
measures reduce the risk of starting
the power tool accidentally.
d. Store idle power tools out of
the reach of children and do not
allow persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e. maintain power tools. check
for misalignment or binding of
moving parts, breakage of parts
and any other condition that may
affect the power tool's operation.
if damaged, have the power
tool repaired before use. Many
SKU 95082 For technical questions, please call 1-800-444-3353.
accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and
f.
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
g. use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed.
Use of the power tool for operations
different from those intended could
result in a hazardous situation.
5. Service
a. Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.

Specific Safety Warnings

1. Always wear ANSi-approved
safety impact eye goggles and
heavy-duty work gloves when
using Planer. Using personal safety
devices reduce the risk for injury.
Safety impact eye goggles and
heavy work gloves are available from
Harbor Freight Tools. Dust mask,
non skid safety shoes, hard hat, or
hearing protection must be used for
appropriate conditions.
2. use a platform, or other practical
way, to support a long workpiece
as it enters the Planer. Holding the
work by hand or against your body
is unstable and may lead to loss of
control.
Page 4