THR10/THR5
■
DISASSEMBLY PROCEDURES (分解手順)
1.
Top Cover Assembly
(Time required: About 2 minutes)
1-1
Using an Allen hex socket screw driver (size: 4 mm),
remove the four (4) screws marked [50]. Remove the
two (2) screws marked [54A] and the three (3) screws
marked [54B]. (Fig. 1)
Front view (前面)
[50]
[54A]
1-2
Lift the top cover front lower side after pulling it toward
you. Disconnect the two (2) connector assemblies
from CB9 and CB502 on the MAIN circuit board. The
top cover assembly can then be removed. (Fig. 2)
10
Bottom view (底面)
MAIN
THR10
1.
メタルグリル Ass'y(所要時間:約 2 分)
1-1
六角レンチ(4mm)で[50]のネジ 4 本を外します。
[54A]のネジ 2 本、 [54B]のネジ 3 本を外します。
(図 1)
Rear view (後面)
[50]
[54A]
Fig. 1
(図 1)
1-2
トップカバーのフロント下側を手前に引いてから持
ち上げます。MAIN シートの CB9、CB502 から 2 つ
の束線を外し、 トップカバー Ass'y を外します。 (図 2)
CB502
CB9
Fig. 2
(図 2)
[54B]
Top cover assembly
(ト ップカバー Ass'y)