Brother STAR240E Service Manual page 28

80. Align the feed bracket assembly fear section and install with the two tightening screws. (See Adjustment
Procedure 18.)
81. Hang the feed regulator tension spring on the feed bracket assembly and feed regulator.
82. Install reverse sewing lever B on the arm and hang the tension spring on the reverse sewing lever B and
feed bracket assembly.
83. Install reverse sewing lever A with the screw and lock ring.
84. Install the Zigzag connecting rod on the selection unit with the lock ring, tighten with the two screws, install
on the needle bar block assembly with the Zigzag adjustment nut, hang the spring, for forked connecting rod
hang the tension spring on the oscillating link and screw. Install the Zigzag dial assembly with the two
screws and install with the lock ring.
85. Install the thread tension connecting rod assembly with the two screws.
Assembly Points
80. Install the feed bracket assembly screws in the order (A), then (B). After installing the feed bracket
assembly, be careful about backlash at the feed bracket assembly gear. (See Adjustment Procedure 18.)
81. Hang the feed regulator tension spring with the shorter hook section on the feed bracket assembly.
84. Hang the feed regulator tension spring with the longer hook section on the feed bracket assembly.
84. Install the Zigzag adjustment nut with the hex nut section facing up.
85. When installing the thread tension assembly, lower the presser lifter and pass the thread tension
assembly thread slack plate B tip D through the (C) hole in thread slack plate C. After installing the thread
tension assembly, raise and lower the presser lifter and check that the thread tension adjuster plate opens
and closes.
BW switch (STAR240E, STAR230E only)
Backstitch switch
(STAR240E,
STAR230E only)
www.promelectroavtomat.ru
-26-