PREMIER POLYSTEEL 938-45D-2 Quick Manual

Part No.
652-017
652-026
516-058
516-028
516-023
1 Position the support frame in the desired location and mark ground where holes need to be
drilled.
2 Drill plastic out of the mounting holes on the seats and stand using a 7/16" dia. drill bit.
3 Fasten the seats to the stand loosely.
4 Make sure that the three seats are level with each other and tighten all of the bolts.
5 Support the seats and frame at the desired height in the holes.
6 Fill holes with concrete and crown the top so that water will run off. Let stand for at least 24
hours before removing supports.
In Accordance to California law: WARNING This product contains a chemical know to the State of California
to cause cancer and birth defects or other reproductive harm.
938-45D-2
3
72
8
12
Description
45deg Contour Seat
45 deg Arc Support Frame
Direct Bury
3/8" X 1-1/2" SS Hex Bolt
3/8" SS Nylock Nut
3/8" SS Washer
Periodic check of bolt tightness recommended.
11
28
16
1
18
2
Qty.
3
1
18
18
36