When the monitor goes into power-save mode, the following message appears:
If either HDMI or DisplayPort cable is not connected, a floating dialog box as shown
below appears. The monitor will enter Standby Mode after 4 minutes if left at this
state.
NOTE: The message may be slightly different according to the
connected input signal.
Are you sure you want to lock the Menu Buttons?
To unlock the Buttons, refer to the User's Guide.
Yes
No
Going into Standby mode...
No HDMI Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2X23D
or
No DP Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2X23D
Operating your monitor
│
55