Kenwood DV-2070 Instruction Manual page 5

13. Lightning - For added protection for this appliance during a
lightning storm, or when it is left unattended and unused for
long periods of time, unplug it from the wall outlet and
disconnect the antenna or cable system. This will prevent
damage to the appliance due to lightning and power-line
surges.
DV-2070 (En/KJ
18. Power lines - An outside antenna system should not be
located in the vicinity of overhead power lines or other electric
light or power circuits, or where it can fall into such power
lines or circuits. When installing an outside antenna system,
extreme care should be taken to keep from touching such
power lines or circuits as contact with them might be fatal.
14. Abnormal smell - If an abnormal smell or smoke is detected,
immediately turn the power OFF and unplug the appliance
from the wall outlet. Contact your dealer or nearest service
center.
POWER OFF!
15.
Damage requiring service
- The appliance should be ser¬
viced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the
appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally by
following the instruction manual. Adjust only those controls
that are covered by the instruction manual as an improper
adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to
restore the appliance to its normal operation.
E.
The appliance has been dropped, or the enclosure dam¬
aged.
F. The appliance exhibits a marked change in performance.
16.
Servicing
- The user should not attempt to service the
appliance beyond that described in the instruction manual. All
other servicing should be referred to qualified service person¬
nel.
17.
Outdoor antenna grounding
- If an outside antenna is
connected to the appliance, be sure the antenna system is
grounded so as to provide some protection against voltage
surges and built up static charges. Article 810 of the National
Electrical Code ANSI/NFPA 70. provides information with
respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna dis¬
charge unit, size of grounding conductors, location of antenna
discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode. See Figure.
19. AC outlets - Do not connect other audio equipment with a
power consumption larger than that specified to the AC outlet
on the rear panel. Never connect other electrical appliances,
such as an iron or toaster, to it to prevent fire or electric shock.
20. Overloading-Do not overload wall outlets, extension cords,
or integral convenience receptacles as this can result in a risk
of fire or electric shock.
21. Attachment - Do not use attachments not recommended by
the appliance manufacturer as they may cause hazards.
22. Replacement parts-When replacement parts are required,
be sure the service technician has used replacement parts
specified by the manufacturer or have the same characteris¬
tics as the original parts. Unauthorized substitutions may
result in fire, electric shock, or other hazards.
23. Safety check - Upon completion of any service or repairs to
this appliance, ask the service technician to perform safety
checks to determine that the appliance is in proper operating
condition.
1 Item 3 is not required except for grounded or polarized equipment.
2. Item 17 and 18 are not required except for units provided with antenna
terminals.
3. Item 17 complies with UL in the U.S.A