Removal steps
Device in the flex bay
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
The flex bay of your computer supports the following devices:
• Flex module
• Front-access storage enclosure
• Multi-drive conversion kit
• Slim-optical-drive adapter
Note: The following instructions on how to remove or install a slim-optical-drive adapter also apply to other
supported devices in the flex bay.
For access, do the following:
1. Remove the computer cover. See "Computer cover" on page 58.
2. Locate the flex bay. See "Internal storage drives" on page 56.
3. Disconnect the signal cable and the power cable from the rear of the slim optical drive.
Note: If you are removing other supported devices from the flex bay, disconnect any additional cables
first.
Replacement steps
1. Remove the slim-optical-drive adapter.
.
Chapter 7
Hardware removal and installation
63