Advertisement
IV. Wiring Diagram
For DC use only
For AC/DC
Note:
1. It is suggested to use #22~26 AWG insulation wire.
2. It is suggested to use a linear power supply unit to prevent the reduction of reading range.
3. The door strike or relay must have a varistor or a diode across the door strike terminals to suppress
the back EMF of the strike. Failure to do so will damage the relay contacts and electronic components
, or even burn the controller.
4. Exit button is at N.O. contact.
V. Operation Instruction
1. Set Master Card
Yellow and Green LED flash indicates that the memory is empty. The first card read by the reader
will be the Master Card.
Read the Master Card (Yellow LED stay on), enter standby mode
Note: The same Master Card can be used on more than one reader.
2. Add new cards
1. Read Master Card once (Green LED stay on for 3 seconds, then flash), enter adding card mode
2. Read the new card(s) (relay active → successfully adding the new card)
3. Read Master Card once (Green LED off, Yellow LED stay on), back to standby mode
Note: It is suggested to use the card of ABA form codes and make a list of the cards added to the
reader.
3. Delete cards
1. Read Master Card twice within 2 seconds (Red LED stay on for 3 seconds and flash), enter
deleting card mode
2. Read the card(s) (Green LED stay on → successfully delete cards)
3. Read Master Card once (Red LED off, Yellow LED stay on), back to standby mode
Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-EASIPROX Ver. F Published on 2011.02.14
Red
12 VDC
(polarity free)
Red
12 VDC
(polarity free)
White
Com.
Yellow
N.C.
Blue
N.O.
Green
Exit Button
Green
Exit Button
Black
Clear all memory
Black
Clear all memory
Page: 2/ 4
Advertisement
