EASIPROX
I. Features
1. Memory volume up to 2000 proximity cards/tokens. Reading time approx. 0.5 seconds.
2. Programming via Master Card.
3. Preventing re-entering the same card.
4. Non-volatile memory stores all cards even in the event of total power failure or when the reader is
not in use for a long time.
5. Epoxy sealed. Standard size of single-gang box.
II. Specification
Operating Voltage
Current Draw
RF Frequency
Read Range
Input
Output
LED Status Indication
Memory Volume
Format
Relay Rating
Relay Strike Time
Ambient Humidity
Operating Temperature
EMC Specification
III. LED Status Indication
Mode
Signal
Standby
Yellow & Green LED flash
Yellow LED On
Green LED On
Red LED On
Programming
Green LED flash
Red LED flash
Yellow & Red LED flash
Yellow LED flash
Green LED flash
Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-EASIPROX Ver. F Published on 2011.02.14
EASIPROX Stand Alone Reader
Operation Manual
EASIPROX-ANSI
12 VAC/VDC
Pull In: 70 mA/12 VDC; Holding: 45 mA/12 VDC
125 KHz (ABA form code)
10~15 cm (depending on local installation conditions)
1 contact for Request-To-Exit button
1 relay (Dry contacts: N.O./N.C./Com.)
2-LED indicators (Yellow & Green / Red); 3-LED indicators
(Yellow, Green, Red)
2000 proximity cards/tokens
EM-400x 64-bit Standard R/O or Compatible
Max. 5A/250 VAC
0.7 ~ 42 seconds
5%~95% (Non-condensing)
-20°C~70°C
Meet CE requirement
Status
No Master Card (empty memory)
Standby
Relay strike time
Invalid card
Add cards
Delete cards
Clear memory
Adjustment of relock time (1 ~ 60
flashes, 0.7 ~ 42 seconds)
Clear all memory (including Master
Card)
Unit: mm
EASIPROX-980-40
Page: 1/ 4
114