Ryobi PowerPlus HT12V Operator's Manual
Ryobi PowerPlus HT12V Operator's Manual

Ryobi PowerPlus HT12V Operator's Manual

12 volt - 18 inch battery hedge trimmer

Advertisement

Quick Links

HT12V
12 Volt - 18 Inch Battery Hedge Trimmer
OPERATOR'S MANUAL
FOR QUESTIONS, CALL 1-800-345-8746 in U.S. or
1-800-265-6778 in CANADA
www.ryobi.com
IMPORTANT MANUAL
DO NOT THROW AWAY

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi PowerPlus HT12V

  • Page 1 HT12V 12 Volt - 18 Inch Battery Hedge Trimmer OPERATOR’S MANUAL ™ FOR QUESTIONS, CALL 1-800-345-8746 in U.S. or 1-800-265-6778 in CANADA www.ryobi.com IMPORTANT MANUAL DO NOT THROW AWAY...
  • Page 2: Table Of Contents

    INTRODUCTION TABLE OF CONTENTS THANK YOU Safety Warnings ....3-5 Thank you for purchasing this quality product. Operating Instructions ... . .6-10 This modern outdoor power tool has been A.
  • Page 3: Safety Warnings

    SAFETY WARNINGS THE PURPOSE OF SAFETY SYMBOLS IS TO WARNING: Failure to obey a safety warning can result in serious injury ATTRACT YOUR ATTENTION TO POSSIBLE to yourself or to others. Always DANGERS. THE SAFETY SYMBOLS AND THE follow the safety precautions to EXPLANATIONS WITH THEM, DESERVE YOUR reduce the risk of fire, electric CAREFUL ATTENTION AND UNDERSTANDING.
  • Page 4 • DO NOT USE accessories or attachments • When not in use, store hedge trimmer not sold or recommended by Ryobi to void indoors in a dry place —where it is not the risk of fire, electric shock or jury to accessible to children.
  • Page 5 SAFETY WARNINGS • To reduce risk of electric shock, unplug the • SAVE THESE INSTRUCTIONS. Refer to them 12V charger from outlet before attempting frequently and use them to instruct other any maintenance or cleaning. users. If you loan someone this tool, also loan them these instructions.
  • Page 6: Operating Instructions

    8. CHARGING STAND — holds battery. 9. 12V CHARGER — plugs into wall outlet and charging stand. Charges battery. BATTERY AND CHARGING STAND Your hedge trimmers requires a Ryobi #181918 battery, charging stand #181919, and 12V Fig. 2 charger #181925. The charging instructions...
  • Page 7: Charging Stand Mounting

    OPERATING INSTRUCTIONS CHARGING STAND MOUNTING WARNING: To reduce the risk of See Figure 3. injury, charge only nickel-cadmium rechargeable batteries. Other types When mounting the charging stand into a of batteries may burst causing plaster board wall, drill two 7/32 in. (5.56 mm) personal injury or damage.
  • Page 8: To Charge Battery

    OPERATING INSTRUCTIONS 8. The hedge trimmer should not be stored at 1. Charge battery only with the 12V charger provided. temperatures above 100º F (37º C) because high temperatures will shorten the life of the 2. Plug 12V charger into the wall outlet and its battery.
  • Page 9: To Install Battery

    OPERATING INSTRUCTIONS 3. Release the lock-off button. WARNING: TO AVOID serious personal injury, ALWAYS use both NOTE: The lock-off button is located on top the front (wrap-around) and rear of the rear handle. The lock resets handles to hold the hedge trimmer each time the trigger is released.
  • Page 10: To Trim A Hedge

    OPERATING INSTRUCTIONS Do not try to cut stems that are larger than WARNING: If any parts are missing 3/8 inch thick, or those obviously too large to or damaged, do not operate your feed into the cutting blade. Use a non-powered hedge trimmer until they have been hand saw or pruning saw to trim large stems.
  • Page 11: Maintenance And Repair Instructions

    MAINTENANCE AND REPAIR INSTRUCTIONS WARNING: When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage. Only the parts shown on parts list, page 13, are intended to be repaired or replaced by the customer.
  • Page 12: To Install Blade

    MAINTENANCE AND REPAIR INSTRUCTIONS 5. Each blade has an oval yoke attached to its NOTE: If binding occurs after replacing the end. Slide the blades into position so the blade assembly, repeat the steps yokes align. Remove the blade from the under To Remove Blade and To housing (Fig.
  • Page 13: Replacement Parts

    REPLACEMENT PARTS Item Part No. Description 181918 BATTERY 181919 CHARGING STAND 181920 REPLACEMENT BLADE 181921 FRONT (WRAP-AROUND) HANDLE 181662 FRONT HANDLE SCREW 181922 BLADE COVER 181923 GUARD 181665 GUARD SCREW 181924 BOTTOM PLATE 181667 BOTTOM PLATE SCREW 181925 12V CHARGER (Model No. 4400101) 181667 BLADE SCREW SPECIFICATIONS...
  • Page 14: Warranty

    PRODUCT DURING THE TIME WARRANTY of the contract of sale of any RYOBI Product. Proof of SERVICE IS BEING PERFORMED, TRAVEL, LOSS purchase will be required by the dealer to substantiate OR DAMAGE TO PERSONAL PROPERTY, LOSS OF any warranty claim.

Table of Contents