Fuel Evaporation System Filter; Fuel & Evaporative System Line Routings - HUSTLER Super S General Service Manual

Table of Contents

Advertisement

Kawasaki FX691V/FX850V engine
A. Safety filter
Figure 5-5
6. Never operate the machine without an air filter
installed.
Overservicing
Overservicing occurs when an air filter element is removed
for cleaning or replacement before it is necessary. Each time
the filter is removed a small amount of dirt and dust could
fall in the intake system. This accumulated dirt can cause a
dusted engine. It only takes a few grams of ingested dirt over
the normal service life of an engine to cause a dusted engine.
Do not clean the element, but replace with a new element
only. Cleaning used air filter elements, through improper
cleaning procedures, can get dust on the inside of the filter
causing dirt ingestion and engine failure.
It is important to note that whenever an air filter element is
cleaned by any method, the person or company performing
the cleaning assumes responsibility for the integrity of the
filter from then on. The warranty for air filters expires upon
cleaning or servicing in any manner because the condition of
the filter after servicing is completely out of the filter
manufacturer's control. Therefore, on a dust ingested engine
failure, there will be no warranty consideration if the air filter
element has been cleaned or serviced in any manner.
A partially dirty air filter element works better than a new
element. Therefore, a dirty filter element is not bad for the
127180
A
engine unless it is excessively restricting the air flow and
engine performance is affected. The reason is simple. The
media in the filter must be porous to allow air to pass
through it. When dirty air passes through the filter, the dirt
plugs some of the holes in the media and actually acts as
part of the filter media. When the next round of dirt enters,
the first dirt helps filter out even smaller particles making the
filter more efficient at stopping dirt from entering the engine.
This is referred to as barrier filtration.
Of course, at some point the filter media becomes too
clogged to allow air to pass.
The mowing conditions will determine the frequency of air
filter element changing.

Fuel Evaporation System Filter

These mowers have a fuel evaporation system filter. This
filter must be checked and replaced every 500 hours or
annually whichever comes first. Figure 5-6
A. Fuel evaporation system filter
Fuel & Evaporative System Line Routings
These mowers have a fuel evaporative system installed.
There are two different types of rubber hoses that are
connected to the fuel tank. One is the fuel hose that is part of
the fuel system. The other is the vapor line that is part of the
fuel evaporative system.
5-3
A
Figure 5-6
REV A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents