Table of Contents
Advertisement
PROBLEM
"F–AND A NUMBER
OR LETTER" FLASH
IN THE DISPLAY
DISPLAY GOES BLANK
DISPLAY FLASHES
UNABLE TO GET THE
DISPLAY TO SHOW "SF"
CONTROL SIGNALS AFTER • This is reminding you to press BAKE and then enter a temperature.
ENTERING COOKING TIME
OR DELAY START TIME
CLOCK AND TIMER
DO NOT WORK
SURFACE UNITS NOT
FUNCTIONING PROPERLY
OVEN WILL NOT WORK
FOOD DOES NOT
BROIL PROPERLY
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
• This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
hour. Place the oven back into operation.
• Disconnect all power to the oven for 5 minutes and then reconnect power.
If the failure code repeats, call for service.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• Power failure. Reset the clock.
• BAKE and BROIL HI/LO must be pressed at the same time and held for
2 seconds.
• This is reminding you to enter a bake temperature after having
pressed BAKE.
• Make sure the electrical plug is plugged into a live, properly grounded
power outlet.
• Check for power outage.
• See the Oven Control, Clock and Timer section.
• Surface units are not plugged in solidly.
• Surface unit controls are not properly set.
• The plug on the range is not completely inserted in the electrical outlet.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• The oven controls are not properly set.
• Oven controls not set properly. See the Broiling section.
• Door not left open to the broil stop position as recommended.
• Improper shelf position being used. See the Broiling Guide.
• Food is being cooked on a hot pan.
• Cookware is not suited for broiling.
• Low voltage. See the Broiling section.
• Aluminum foil used on the broiler pan and grid has not been fitted properly
and slit as recommended.
(continued next page)
31
Advertisement
Table of Contents
