Database Information For Terrain - Garmin GNC 420(A) Pilot's Manual & Reference

10.4 DATABASE INFORMATION FOR
TERRAIN
General Database Information
Garmin TERRAIN uses terrain and obstacle
information supplied by government sources. The data
undergoes verification by Garmin to confirm accuracy of
the content, per TSO-C151b. However, the displayed
information should never be understood as being all-
inclusive. Pilots must familiarize themselves with
the appropriate sectional charts for safe flight.
NOTe: The data contained in the terrain and
obstacle databases comes from government
agencies. Garmin accurately processes and
cross-validates the data, but cannot guarantee
the accuracy and completeness of the data.
The terrain/obstacle databases are contained on a
datacard which is inserted in the right-most slot of the
GNC 420 units (Appendix A).
NOTe: Obstacles 200' and higher are included
in the Obstacle Database. it is very important
to note that not all obstacles are necessarily
charted and therefore may not be contained in
the Obstacle Database.
190-00140-20 Rev. K
Database Versions
The version and area of coverage of each terrain/obstacle
database is shown on the Terrain Database Versions Page,
located in the AUX Page Group (Figures 10-10 and
10-11, also Section 9.3). Databases are checked for
integrity at power-up. If a database is found to be missing
and/or deficient, the TERRAIN system fails the self-test
and displays the TERRAIN system failure message (see
Table 10-3).
GNC 420(A) Pilot's Guide and Reference
Figure 10-10 Utility Page
Figure 10-11 Terrain Database Versions Page
SECTION 10
TERRAIN
10-9