Canon BS1 Service Manual page 23

4
Installation > Installation Procedure
4) Remove tapes from contents.
5) Separate the Punch Dust Box Frame Unit and the Punche Dust Box Unit.
Punch Dust Box Unit
6) Align and insert the 2 holes on the Punch Box Frame Unit to the 2 pins on the positioning
pins inside the Finisher to install it.
• 1 Screw (RS tightening; M4x8)
CAUTION:
When tightening screws, press down with the finger to prevent the Puncher Dust Box
Frame Unit from moving.If the Puncher Dust Box Frame Unit is installed at an angle, it
will be difficult to install the Puncher Dust Box Unit due to the interference.
4 Installation > Installation Procedure
Punch Dust Box Frame Unit
F-4-8
F-4-9
Punch Box
Frame Unit
Punch Box
Frame Unit
4-5
[1]
Positioning Pin
Punch Box
Frame Unit
Hole
F-4-10
4-5