To Change The Cable Entry - Furuno 2127 Installation Manual

1. MOUNTING

To change the cable entry

To change the cable entry from the side (default) to the bottom, modify the unit as shown
below.
Screw
M3x8
3. Pass the cable from this hole.
4. In here, clamp the copper part
of the cable with the cable
clamp removed at step1.
J522: If you connect RCU-016 in series with RCU-015, plug in here.
1-14
RCU-015/016: Changing cable entry
Bottom of the unit
2. Pull out the cable.
Cable clamp
03-163-7804
Screw
M4x8
1. Remove the
cable clamp.