Lubrication Points - Land Pride RTR05 Series Operator's Manual

Section 4: Maintenance & Lubrication

Lubrication Points

Lubrication
Legend
23760
23759
23771
3/2/22
Table of Contents
Multi-purpose
spray lube
Multi-purpose Multi-purpose
grease lube oil lube
Driveline U-Joint
Driveline U-joint with grease every 8 hours of operation
Type of grease = Multi-Purpose
Quantity = Coat Generously
Driveline Shaft
Disconnect driveline shaft from the tractor and slide
apart. Clean and coat the inner tube of the driveline shaft
with a light film of grease and then reassemble.
Type of grease = Multi-Purpose
Quantity = Coat Generously
Chaincase
IMPORTANT: Tiller should be level when checking
oil level in chaincase. Check oil level by removing
lower level plug. Oil should reach bottom of plug
hole. Remove fill plug and add recommended
lubrication as needed. Tighten both plugs when
done.
Type = Recommended: Shell Alvania EP00 Oil
Alternate: SAE 90 wt. oil
Quantity = As required
RTR0542 & RTR0550 Rotary Tillers 311-464M
50
Intervals in hours at which
lubrication is required
Hrs
8
Hrs
20
Hrs
As
Required
25