Advertisement
STEP 7
Take slat (K), the crossbar, and place this under the back of armrests. Secure
it on each side to the upright back support (F) using 4x40 mm screws. The
K
countersunk edges of the pre-drilled holes should face inwards. Make sure
incorrect
that the plank is firmly attached to the armrests.
K
F
correct
STEP 8
Now take the seven back slats. Lay the slats in the correct order, starting
with the longest one in the middle. Arrange three slats on each side so that
the top of the backrest forms a curved line. The countersunk edges of the
pre-drilled holes should face inwards. Take the middle, longest slat, fasten it
using a 4x40 mm screw to the low rear support (B), and then to the upper
back support (J). Make sure that the underside fits exactly in the notch and
that the slat is parallel on the underside to the bottom of the low back
support.
STEP 9
Now secure all the slats correctly to the bottom of back support (B) using
L1-7
4x40 mm screws. Do not fasten the screws at the top before checking that
all slats are in the correct position and that the upper edge forms a nice,
curved line. The spacing between the slats should be even. Use the notches
1st
as reference points. When all slats are correctly positioned, they can be
secured at the top using 4x40 mm screws.
2nd
Advertisement
