Advertisement
STEP 1
Lay sidepieces (A) with the curved sides uppermost on a flat surface. The
B
countersunk side of the pre-drilled holes should face outwards. Then place
the flat rear support (B) in the last notch at the back end of the sidepieces
(A). Keep the curved side with the notches facing the front and the
Back!
countersunk edge of the pre-drilled holes facing upwards. Secure the plank
using two 4x 40 mm screws on each side. Make sure that the plank fits
properly. Secure plank (C) between the two sidepieces. Use two 4x40 mm
C
screws on each side. Screw them into the two smaller pre-drilled holes.
Front!
STEP 2
Now place all slats (D1-7), EXCEPT part M, in the notches on top of
sidepieces (A). Make sure that they fit exactly and that the outer edges of
the slats are precisely aligned with the outer edges of the big side pieces.
Use a 4x40 mm screw on each side of the slats. Work from bottom to top.
Make sure that the countersunk edge of the holes is facing upwards.
STEP 3
Next, attach the front legs (E) and the upright back supports (F). At the front
Inside!
F
of the sidepiece, place two nuts in the large pre-drilled holes on the inside.
E
At the back, place the bolts in position on the outside. Take the chair legs (E)
and secure them with the bolts onto the outside of the sidepiece. At the
back, secure the upright back supports (F) on the inside using the remaining
bolts. Make sure that the countersunk edges of the small holes at the top of
the chair legs (E) and on the back supports (F) are facing inwards. Repeat on
Outside!
the other side of the chair.
Advertisement
