MAINTENANCE
156
To remove the battery:
▼ Turn the ignition to the OFF position
and wait at least 2 minutes for the
engine ECM to complete its power
down sequence.
▼ Remove the passenger seat, see
page 90.
▼ Remove the rider seat, see page 91.
1.
Battery tray cover
2.
Negative (black) battery lead
3.
Battery
4.
Battery strap holder hook
5.
Battery strap
6.
Battery strap hook
7.
Positive (red) battery lead
8.
Rear suspension unit lead
▼ Disconnect
battery lead.
▼ Disconnect the positive (red) battery
lead and position away from the
terminal.
▼ Disconnect the rear suspension unit
lead.
1
2 3
4
8
7
6
5
the
negative
(black)
▼ Release the battery strap from the
hook and attach to the battery
strap holder hook.
1.
Battery tray cover
2.
Battery
▼ The battery tray cover is hinged
for easy access. Carefully lift and
tilt the battery tray cover towards
the rear of the motorcycle to gain
access to the battery. Take care not
to stretch, pull or trap any leads.
▼ Remove the battery.
Battery Charging
Caution
Over charging and severe discharging
will damage the lithium-ion battery.
Do not allow the voltage at rest to fall
below 12.4 Volts.
Always
check
that
voltage is limited to the voltage shown
in the Maximum Charge Rate table.
1 2
the
charging