Table of Contents
Advertisement
– Regularly clean surfaces that
may come into contact with food
and accessible drainage systems.
– Clean water tanks if they have
not been used for 48 h; flush the
water system connected to a
water supply if water has not been
drawn for 5 days.
– Store raw meat and fish in
suitable
containers
refrigerator, so that it does not
come into contact with or drip
onto other food.
–
Two-star
compartments are suitable for
storing pre-frozen food, storing or
making ice cream and ice cubes.
– Do not freeze fresh food in one,
two or three-star compartments.
– If the refrigerating appliance is
left empty for long periods, switch
off, defrost, clean, dry, and leave
the door open to prevent mould
developing inside the appliance.
INSTALLATION
The appliance must be handled
and installed by two or more
persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including water
supply
(if
connections and repairs must be
carried
out
technician. Do not repair or
replace any part of the appliance
unless specifically stated in the
user manual. Keep children away
from the installation site. After
unpacking the appliance, make
in
frozen
food
any),
electrical
by
a
qualified
sure that it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest After-sales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.)
must be stored out of reach of
children - risk of suffocation. The
appliance must be disconnected
the
from the power supply before any
installation operation - risk of
electrical shock.
During installation, make sure the
appliance does not damage the
power cable - risk of fire or
electrical shock. Only activate the
appliance when the installation
has been completed.
Be careful not to damage the
floors (e.g. parquet) when moving
the appliance. Install the appliance
on a floor or support strong
enough to take its weight and in a
place suitable for its size and use.
Make sure the appliance is not
near a heat source and that the
four feet are stable and resting on
the floor, adjusting them as
required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance
on, to ensure that the refrigerant
circuit is fully efficient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or
fixing of the appliance must be
EN - 7
Advertisement
Table of Contents
