Yamaha ARIUS YDP-165 Owner's Manual page 36

Keyboard Stand Assembly
6.
Connect the pedal cord plug and the
power plug.
Cord holder
6 - 1
TO PEDAL DC IN
6-1
Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
Insert the plug until the metal part disappears
from view.
NOTICE
If it is not plugged in firmly, it may cause the pedals to
not work.
6-2
Wind the cord holders around pedal cord to
hold it.
The cord holders are attached to the side board
(L).
36
YDP-165, YDP-145, YDP-S55, YDP-S35 Owner's Manual
6 - 4
Metal part
6-3
(YDP-165 only) Connect the power cord to
the AC adaptor.
6 - 2
6-4
Insert the DC plug into the DC IN jack.
7.
Rotate the adjuster until it presses in
firm contact with the floor surface.
Make sure that the pedal box does not rattle or
give way when you step on the pedals.
To press against
the floor
8.
(YDP-165 only) Attach the
headphone hanger.
Use the included two screws (4 x 10 mm) to attach
the hanger as shown in the illustration.
To separate from
the floor
× 2
Included screws
(4 × 10 mm)