Senco AC33024 Operating Instructions Manual page 11

3
ABNORMALITIES CAUSE
The appli- Leakages
ance restarts from the air
numerous pipe, utensil
times even or pneumatic
without a system.
utensil.
The utensil The tank is not
does not emit pressurised.
air.
Incorrect
regulation
of the outlet
pressure.
The utensil is
damaged.
Fall of pres-
Leakages in
sure in the air
the air pipe,
tank.
utensil or the
pneumatic
system.
Safety valve Pressure
intervention. switch fault.
SOLUTION
• Check that the pneu-
matic system is not
damaged.
• Check that the air
pipe and utensils are
intact as well as the
connections.
• Switch on the appli-
ance and wait until
the tank fills checking
the pressure of the
relevant gauge.
• Check that the value
displayed on the outlet
pressure gauge (A) is
greater than 0 (zero)
bar.
• Check that the utensil
is intact and effective.
• Check that the pneu-
matic system is not
damaged.
• Check that the air pipe
and utensil are not
damaged.
• Check that the appli-
ance-air pipe and air
pipe-utensil connec-
tions are correct.
• Check that the
condensate pump is
securely closed (B).
• Contact an authorised
Supplier.
Air loss from Unclean or
the pressure worn return
switch when valve.
appliance
is off.
The appli- Mechanical
ance vibrates fault.
and/or emits
lots of noise.
Frequent Unclean air
start-ups and filters.
low perfor-
mance.
11
• Contact an authorised
Supplier.
• Contact an authorised
Supplier.
• Carry out filter clean-
ing (see Paragraph 25).
A
B
EN