Hexadecimal Dump - Epson TM200 Service Manual

1.7

Hexadecimal Dump

Hexadecimal Dump Function
This function prints the data transmitted from the host computer in hexadecimal
numbers and in their corresponding characters.
Performing a Hexadecimal Dump
To use the hex dump feature, follow these steps:
1. After you make sure that the printer is off, open the cover.
2. Hold down the FEED button while you turn on the printer.
3. Close the cover.
4. Run any software program that sends data to the printer. The printer prints
"Hexadecimal Dump" and then all the codes it receives in a two-column format.
The first column contains the hexadecimal codes and the second column gives
the ASCII characters that correspond to the codes.
Hexadecimal Dump
1B 21 00 1B 26 02 40 40 ← !
1B 25 01 1B 63 34 00 1B ←%☺← c 4
41 42 43 44 45 43 47 48 ABCDEFGH
5. Close the cover and turn off the printer or reset it to turn off the hex dump
mode. (or to terminate hex dump, press FEED button three times, and
when you see
Note:
Insufficient print data to fill the last line can be printed by setting the printer offline.
Ending hexadecimal dumping
Hexadecimal dumping ends by turning the power off or resetting the printer via
the interface after printing has finished.
← & ☻ @ @
*** completed ***
the hex dump mode was turned off.
- 15 -
TM200 Service Manual
←