Table of Contents
Advertisement
Miscellaneous jumper settings (continued)
* Factory setting
** Jumpers JB and JE must be set to the same position to enable ordisable
the hard disk drive controller
*** Default setting dependson the type of factory-installed microprocessor
Microprocessor type jumpersettings
*
Default setting dependson the type of factory-installed microprocessor
Microprocessor voltage jumper settings (1)
(1) To determine the voltage of your microprocessor, see page 3-23.
(2) Default setting
(3) The setting of J33 does not matter if you are using a 5 VoIt microprocessor
Built-in VGA controller jumper settings
Function
Enable built-in VGA controller
I
Disable built-in VGA controller
* Default setting
Discharges CMOS memory (this resets the SETUP values to
J14
Installing and Removing Options
J15
3 - 7
Advertisement
Table of Contents
