Installing The Option - A&D AD-4402 Instruction Manual

3.1. Installing the option

3.1. Installing the option
3.1. 3.1. Installing the option Installing the option
Caution
Remove the power cord before installing the option.
Do not touch an inside parts within ten seconds after removing the power cord
because you may receive an electric shock.
Do not forget to tighten the screw. If the screw is not tightened, it may cause
short circuit or an error due to noise.
Three option boards can install in the slots.
Initialize the RAM data in accordance with proper procedure.
Refer to the instruction manual of AD-4402 for other information.
AD-4402-20 Page 5