Remote Control - Dish Network Solo 301 User Manual

Dish networks receiver user guide
Hide thumbs Also See for Solo 301:
Table of Contents

Advertisement

Chapter 2
Parts of the System
Page 6
R
C
EMOTE
ONTROL
This section describes the remote control and how to use the buttons to operate
the satellite receiver.
For information on using the remote to control other devices, go to the section
titled Control Other Devices with the Remote, beginning on page 11.
If you lose or damage the remote control, you will not be fully able to control
the receiver. If this happens, call the Customer Service Center at 1-800-333-
DISH (3474) to order a replacement.
Note: This remote control shown in this guide is for example only. The remote
that came with the receiver may look slightly different.
R
C
B
EMOTE
ONTROL
The remote control comes with four AAA batteries. When you replace old
batteries, you should replace all of the batteries. Use batteries of the same kind,
for example alkaline or carbon zinc, and don't mix batteries of different kinds.
Alkaline batteries last longer.
1. Press down on the top of the battery cover and slide the
cover off.
2. Take out all of the old batteries.
3. Put the new batteries in. Make sure you match the plus
("+") ends with the plus markings inside the battery case.
4. Fit the battery cover's bottom tab back into the slot at the
bottom of the battery case, and slide the cover back into
place.
ATTERIES

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents