Orion XTR2502 Owner's Manual page 11

L CH
Bridge Configuration
Bridging allows one speaker to be driven at a higher power level from
the amplifier .
+
L CH
Figure 11
Figura 11
Abbildung 11
+
L CH
© 2008 Directed Electronics. All rights reserved.
R CH
_ _
+
R CH
_ _
+
R CH
three Channel (Channel 1, Channel 2, Bridged)
• Left and Right are configured for two-channel stereo operation .
+
• Lowest recommended impedance is 2
L CH
• the third output is configured for a single channel bridged out-
put .
• the bridged outputs lowest recommended impedance is 4
• outputs are configured for high-pass, low-pass, or full range
operation .
+
L CH
Figure 12
Figura 12
Abbildung 12
NOTE: to get full output in this configuration, band limiting filters as
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits .
_ _
+
Ω stereo .
R CH
_ _
+
R CH
Ω .
10