Note For Repair - Sony DSC-J10 Service Manual

NOTE FOR REPAIR

• Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, do not pull at wire of connector. It is
possible that a wire is snapped.
• When installing a connector, do not press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
DISCHARGING OF THE CHARGING CAPACITOR
The charging capacitor is charged up to the maximum 310 V
potential.
There is a danger of electric shock by this high voltage
when the capacitor is handled by hand. The electric shock
is caused by the charged voltage which is kept without dis-
charging when the main power of the unit is simply turned
off. Therefore, the remaining voltage must be discharged as
described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end
of a resistor of 1 kΩ /1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to
prevent electrical shock.
Wrap insulating tape.
DSC-J10
Cut and remove the part of gilt
which comes off at the point.
(Be careful of that some
pieces of gilt may be left inside)
Note: Note: High-voltage cautions High-voltage cautions
Discharging the Capacitor
Short-circuit between the two points with the Short-circuit between the two points with the
short jig about 10 seconds. short jig about 10 seconds.
To avoid the spark with the metal plate, To avoid the spark with the metal plate,
wrap the short jig with the insulation tape. wrap the short jig with the insulation tape.
ST Board
R:1 kΩ/1 W
(Part code: 1-215-869-11)
Make sure to remove
the battery before
Discharging the Capacitor.
2-2