Connections; Cable Indications; Analog Connections; Digital Connections - Denon DCM-500AE Operating Instructions Manual

ENGLISH

Connections

NOTE:
• Do not plug in the power supply cord until all connections have been completed.
• When making connections, also refer to the operating instructions of the other components.
• Be sure to connect the left and right channels properly (left with left, right with right).
• Making connections with the power turned on could result in noise or damage the speakers.
• Bunching the power supply cords and connection cables together could result in humming or noise.

Cable indications

Connect using the connection cables shown below.
Audio cable
A
Analog connections (Stereo)
(White)
L
(Red)
R
Pin-plug cable
B
Digital connections (Coaxial)
(Orange)
Coaxial cable (75 Ω/ohms pin-plug cable)
C
Digital connections (Optical)
Optical fiber cable

Analog connections

Use the included pin-plug cable to connect the left (L) and right (R) output terminal (LINE OUT) of the CD
Player to the CD, AUX or TAPE PLAY left (L) and right (R) input terminal of the amplifier.
Signal direction
Audio signal
L
R
OUT IN
Stereo amplifier
A
AUDIO IN
L L
R R

Digital connections

• Digital signals are output from optical terminal and coaxial terminal with parallel.
¢ When connecting the OPTICAL digital output connector with an optical
transmission cable (commercially available)
Protective cap
Remove the protective cap, match the shapes then
insert firmly all the way in.

Connecting the power supply cord

L
R
6
ENGLISH
CD recorder etc.
B
C
Match the
shapes
• Store the protective cap in a safe place so as not
to lose it, and use it when not using the terminal.
AC outlet
AC 230 V, 50 Hz
NOTE:
• Insert the plugs securely. Incomplete connections
will result in the generation of noise.
• Do not unplug the power supply cord while the
set is operating.
Connections
COAXIAL
IN
OPTICAL
IN