Advertisement
2. INTRODUCTION
Powerful dehumidification capacity, extracts up to 30 litres of water per day. Removes excess moisture from air, preventing build-up of mildew
and mould. Features auto-defrost function, which activates if the room temperature falls too low. The unit has a 24hr timer function for delay
starting and auto shut-off. Washable activated carbon air filter. Refrigerant is environmentally friendly R290. May be connected to a drain hose
for continuous operation. Mounted on castors for manoeuvrability.
3. SPECIFICATION
Model No.:............................................................ SDH30.V3
CO
Equivalent: .......................................................... 0.0006t
2
Condensate Tank: .............................. 7L (with Auto Shut-Off)
Dehumidifying Capacity: ..................... 30L/day(30
Electrical Plug Type: ................................................ 3-Pin BS
Freezing Pressure(Max): ............................................2.5MPa
Global Warming Potential (Rating) ....................................... 3
IP Rating: ........................................................................IP22
Maximum Airflow: ...................................................... 300m
Power: ................. 420W (27
Refrigerant: ........................................................R290/0.12kg
Steaming Pressure (Max): .........................................1.0MPa
Supply: ...........................................................................230V
Working space: ....................................................... 50-120m
Working Temperature: ................................................. 5-35
4. ASSEMBLY
4.1.
With unit tipped forward, fix axle (fig.1) to underside of unit with the four screws provided.
4.2.
Slide wheels onto the axle and fix in place using the plain washer and locking nut provided.
4.3.
Remove the screws from the handle hinge point, rotate the handle to the upright position and re-fit the screws to fix it in place.
NOTE:
Once upright, DO NOT use the unit for at least 2 hours.
4.4.
WATER TANK USAGE
4.5.
You may use the water tank in two ways.
DIRECT USE. When the water tank is full, the machine automatically shuts down and enters the standby state, the LED displays
4.5.1.
the "Full Water" signal and the dehumidifier will alarm. When the water tank is emptied and put in place again, the dehumidifier can
continue its performance.
4.6.
CONTINUOUS DRAINING
4.6.1.
If there is a place suitable for draining, continuous draining can be carried out. The continuous operation enables the dehumidfying
operation to continue uninterrupted.
4.6.2.
Turn off the dehumidifier, disconnect the power plug and remove the water collection tank.
4.6.3.
Remove the plug from the bottom right hand side of the tank (fig.2) and attach a suitable length hose.
4.6.4.
It should have an inner diameter of 5/8" and secure with a hose clip.
4.6.5.
Thread the hose through the hole in the bottom right hand side of the base of the unit, insert the tank ensuring the hose is not kinked.
4.6.6.
Continue to use the dehumidifier as normal.
NOTE:
When using continuous drainage, the drainage pipe shall not be set higher than the water tank.
© Jack Sealey Limited
CRH80%)
0
C RH60%) 500W(30
C RH80%)
0
0
Locknut & washer
Original Language Version
/h
3
³
C
0
fig.1
fig.2
SDH30.V3
Issue 1 29/07/21
Advertisement
