CORFLEX Ranger ER Application Instructions

°°
CORFLEX.COM | 800 426 7353
Ranger
TM
Pillow w/Sling
Application Instructions
Sizing and Applying the Sling
Shoulder sling features a universal design that accommodates a
wide variety of patients, fitting a forearm length from 9"-20". Length
is measured from wrist to elbow. Sling comes shipped as a typical
medium right arm sling.
Sizing Sling Length and Thumb Loop
1.
A. Release front hook closure
at shoulder strap buckle. Adjust
sling length by removing the
forearm section and reapplying
in the desired position.
B. Proper fit: Edge of sling
should extend to first knuckle
(PIP joint) on the pinkie finger,
ensure elbow is positioned as far
back in the pocket as possible.
C. Release thumb loop strap and
align bottom fold of strap with
third metacarpal.
D. Thumb should rest
comfortably inside loop when
properly fit.
E. Hand should rest fully along
the bottom of the sling and
never be suspended by the
thumb loop.
F. Trim excess strap and secure
to hook at top.
G. Reapply front hook closure to
secure the front panel for use.
ER Shoulder
Applying the Sling
2.
Sling is configured for use on the right arm/shoulder. For left arm
application: properly orient sling, unbuckle strap at wrist end of sling
and rotate before reinserting. Check that strap is not twisted and that
front shoulder strap hook adjustment is accessible from front of strap.
A. Ensure that any open wounds and/
or surgical sites are properly covered
before applying the sling.
B. Release top hook closure at
shoulder strap buckle allowing front
panel of sling to open fully. While
supporting affected arm at 90°,
gently place arm into sling with elbow
positioned as far back as possible in
sling pocket.
C. Edge of sling should extend to first
knuckle (PIP joint) on the pinkie finger. Adjust sling length as needed
for an optimal fit (see Sizing the Sling at left for details).
D. Position thumb loop to help maintain wrist and hand in a neutral
position. Secure hook closure to front panel of sling.
Adjusting Strap Lengths
3.
A. There are two adjustment points for sling shoulder strap length.
Large adjustments should be made at the elbow end of the strap
(backside). After initial fit this closure is typically not adjusted. A more
precise fit can be controlled by the front tab adjustment.
B. On the front strap, release the hook closure and tighten the strap
until the arm is positioned at approximately 90°.
C. Slide the padded neck tube along the strap until it is in the optimal
position for patient comfort.
D. Final adjustments to the shoulder strap length should be made
once the abduction pillow is in place.
Pillow Application
Fitting the Pillow
1.
A. Remove the 2" x 9" mesh strap
and set aside.
B. Orient pillow so that curved
surface is toward body and exercise
ball is at front of pillow. For use on
left arm remove elastic ball holder
and rotate 180°, reattach to front
end of pillow.
C. Apply foam pillow at patient's
waist on their affected side. Wrap
strap around the patient's waist and
secure buckle at the front of pillow.